Operating external devices with the remote control

By registering preset codes for external devices to the provided remote control, you can operate your TV and playback devices (such as Blu-ray Disc player and DVD player) with the remote control.

version Basic

Registering preset codes

When preset codes are registered in the included remote control unit, it can then be used to operate any devices you have, such as DVD players or TVs made by different manufacturers.

nnButtons used for operating the devices

qDEVICE X

For switching power of each device on or off.

wuio p, ENTER, BACK

For menu operation of each device.

eMENU, INFO, OPTION, SETUP

For displaying the menu of each device.

r3, 1, 2, 8, 9, 6, 7 t Number button (0 – 9, +10)

y CH/PAGE df u TV X, TV INPUT

For operating a TV

This button is enabled in any mode.

For details on operation with the remote control unit, see pages 41, 44, 53, 56, 60, 63, 66, 68, 70, 144, 145.

NOTE

The preset code cannot be registered to M-XP, TUNER, PHONO, iPod/USB, NETWORK and INTERNET RADIO.

Registering preset codes

The following two methods can be used for registering the reset code.

qEntering a 4-digit code w Scanning the code table

nnEntering a 4-digit code

See the preset code list table for the code to be input.

1 Press and hold the input source select buttons for the appliance to control, and press SET until indicator blinks twice.

The back light flashes.

NOTE

Note that the group numbers that can be registered are predefined for each input source select button (vpage 142).

2 Press the 4-digit code for the appliance using 0 – 9 (code table at the end of this manual).

When the settings are complete, “OK” is shown in the remote control display.

NOTE

If “NG” is displayed in the remote control display, repeat steps 1 and 2, and enter the same code again.

nnScanning the code table

1 Switch the power on of the device for which you want to set the preset code.

2 Press and hold the input source select buttons for the appliance to control, and press SET until indicator blinks twice.

The back light flashes.

3 Aim the remote control at the appliance and slowly alternate between pressing CH/PAGE d and DEVICE Xfor the appliance. The preset code is shown in the remote control display.

4 Stopoff. when the appliance turns

5 Presscode. ENTER once to lock in the

•Some manufacturers use more than one type of remote control code. Preset codes to change the number and verify correct operation.

•If the AV device is not a marantz device, or if the device does not operate even when the preset code is registered, use the learning function. Remote codes for different devices can be remembered for use by the marantz remote control included with this device.

version Advanced

Information

NOTE

Depending on the model and year of manufacture of your device, some buttons may not operate.

DVD

140