Operating learn function
•If the AV device is not a marantz device, or if the device does not operate even when the preset code is registered, use the learning function. Remote codes for different devices can be remembered for use by the marantz remote control included with this device.
•This remote control unit is capable of learning around 160 codes.
Remembering remote control codes from other devices1 Place the marantz remote control and remote control from the other device approximately 5 cm apart, with the remote control signal transmission sections facing each other.
5 cm
2 Pressblinks.and hold SET until the LEARN indicator
3 Press input source select buttons to select the input source.
The input source is shown in the remote control display.
NOTE
Before using the learning function, register a preset code (vpage 140 “Registering preset codes”) for a mode other than AVR preset (vpage 142) to each input source switch button.
4 Select the button to be learned. LEARN indicator lights up.
DVD
5 Press and hold the button that you want to register on the other remote control until “OK” is displayed on the marantz remote control display.
•If “NG” is shown on the remote control display, perform step 5 again. If “NG” is shown again on the remote control display, the remote control may not be able to learn the code correctly. In this case, use the specialized remote control for the device.
•If the remote control memory becomes full, “FULL” is shown on the remote control display. If you want to learn the code, you should erase other learned button.
6
7 Repeat steps 3 to 6 to learn other input sources.
8 When programming of the remote control unit is completed, press SET.
The LEARN indicator turns off, and the remote control unit exits learn mode.
•There are some remote control units that cannot be programmed, or even if they can be programmed, they may not operate correctly. If this happens, use the remote control unit supplied with the AV equipment to operate it.
•The operations of the programmed buttons override the preset memory. If you do not require the programmed buttons, erase the stored remote control codes to return to the initial settings (vpage 147 “Delete saved remote control codes”).
•The number of buttons that can be stored varies depending on the remote control unit used. If you have stored the maximum number of buttons allowed for the remote control unit, “FULL” appears on its display.
146
NOTE
•The learning function is unavailable for all ZONE SELECT, SET, AVR,
ON/STANDBY X, VOLUME df, FAVORITE STATION, SOUND MODE and input source select buttons in any mode.
•While in the AVR operation mode, the learning function is unavailable.
•The learning procedure does not operate correctly if the batteries have become worn.
•If no buttons are pressed for approximately 1 minutes while in the LEARN mode, the remote control unit automatically exits from the LEARN mode.
version Basic
version Advanced
Information