If the HDMI control function does not operate properly, check the following points.
•Is the TV or player compatible with the HDMI control function?
•Is “HDMI Control” (vpage 117) set to “On”?
•Is “Power Off Control” (vpage 117) set to “All” or “Video”?
•Is “Control Monitor” (vpage 117) set for the monitor output connected to television?
•Is “Control Monitor” (vpage 117) set to the TV that uses the HDMI control function when this unit is connected to two TVs that support HDMI connectors?
•Are the HDMI control function settings of all devices correct?
HDMI control function
NOTE
•When “HDMI Control” is set to “On”, it consumes more standby power.
•The HDMI control function controls operations of a TV that is compatible with the HDMI control function. Make sure that the TV and HDMI are connected when you perform HDMI control.
•Some functions may not operate depending on the connected TV or player. Check the owner’s manual of each device for details beforehand.
•When “Power Off Control” on the menu is set to “Off” (vpage 117), this unit is not set to standby even if the connected device is in the standby mode.
•When connection changes are implemented, such as adding connections to HDMI devices, linked operations may be initialized. In this case, you will need to reconfigure the settings.
•When “HDMI Control” is set to “On”, it is not possible to assign an HDMI connector to “TV AUDIO” at “Input Assign” (vpage 122).
•Should any of the operations below be performed, the interlocking function may be reset, in which case, repeat steps 2 and 3.
•“Input Assign” – “HDMI” (vpage 122) setting has changed.
•“Video Output” (vpage 117) setting is changed.
•There is a change to the connection between the devices and the HDMI, or an increase in devices.
•The HDMI ZONE2 function is not compatible with the HDMI control function.
•When the HDMI ZONE2 function is used with “HDMI Control” in the menu set to “On”, the HDMI ZONE2 function may not fully work.
•If “HDMI Control” in the menu is set to “On” and the power of ZONE2 is on, this units may behave as follows. It is recommended to disable the HDMI control function on your TV and player when using the HDMI ZONE2 function. (Some example behaviors are listed below.)
•When the power of the TV used for MAIN ZONE is off and the player selected for ZONE2 starts playback, the TV used for MAIN ZONE is turned on. In this case, the input source selected for MAIN ZONE changes to the input source selected for ZONE2.
•When playing back a TV used for MAIN ZONE and ZONE2 with an HDMI connection, turning off the TV used for MAIN ZONE also turns off this unit and the player.
•When a same input source is selected for MAIN ZONE and ZONE2, stopping playback of the player on the TV stops the playback on the player and the video being played back in ZONE2 as well.
version Basic
version Advanced
Information
DVD | 93 |