Connecting an external control device

RS-232C connector

When you connect an external control device, you can control this unit with the external control device (such as power supply operation, volume adjustment, and input source switching).

External serial controller

DC OUT jacks

When a device with DC IN jack is connected, the connected device’s power on/standby can be controlled through linked operation to this unit.

The DC OUT jack outputs a maximum 12 V/150 mA electrical signal.

12 V/150 mA trigger-compatible device

version Basic

version Advanced

Perform the operation below beforehand. q Turn on the power of this unit.

w Turn off the power of this unit from the external controller. e Check that the unit is in the standby mode.

DVD

Information

NOTE

•Use the monaural mini-plug cable for connecting DC OUT jacks. Do not use the stereo mini-plug cable.

•If the permissible trigger input level for the connected device is larger than 12 V/150 mA, or has shorted, the DC OUT jack cannot be used. In this case, turn off the power to the unit, and disconnect it.

91