Marantz PV6111W manual Convergence Adjust, Repeat steps 1 and 2, Energy Save setting on

Setup (Continued)

CONVERGENCE ADJUST

Your Rear Projection TV has three color projection tubes: one for red, one for green, one for blue. When mixed together in the proper proportion, the output of these three color tubes can produce any color. To produce these colors, however, the beams must be precisely aligned over each other so that the colors can be mixed. The process of aligning these picture beams is called “convergence”.

Over a period of time, the picture tubes can drift out of alignment due to normal bumps and vibrations or moving the Rear Projection TV. If you move your Rear Projection TV, or if, after a time, you notice color rings or halos around objects in the picture, you may want to converge (align) the colors.

Properly converged, the lines appear white, which is actually a combination of the outputs of the three color tubes. The output of the green tube is stationary. The outputs of the red and blue tubes can be adjusted.

To simplify convergence, this Rear Projection TV incorporates a feature to allow you to display a test pattern of horizontal and vertical lines at nine different locations on the screen. Simply use the remote control to adjust the red and blue colors to match the green.

POWER DTV VCR/ DVD/

STB TV CATV

PERSONAL PREFERENCE

A B C D

ENTER
VOL	CH
MENU
AV MODE
MUTE
	INPUT
	ANT-A/B
	DISPLAY
	ENT. FLASHBACK
TWIN	Q-SOUND
PICTURE
CH	VIEW
	MODE
INPUT	TITLE
REW	FF

CH/SKIP PAUSE STOP REC

VCR/DVD

DDFCPOWER

1	Repeat steps 1 and 2 of the			LANGUAGE
	ENERGY SAVE setting on
				SETUP
	page 52.			GRAY SCREEN
				ENERGY SAVE	SELECT
				CONVER.ADJ.	NEXT
	Press	or	to move the	INPUT MODE	BACK
				CH/INPUT ID	MENU EXIT
	“ ” mark to “CONVER. ADJ.”
2	Press ENTER	or	to	ON
				:CONVER.ADJ.
				OFF
	access the CONVER. ADJ. mode.

	SELECT
	ENTER
	BACK
MENU	EXIT

3	Press	or	to select
	“ON” and then press		ENTER	or

Red

to display nine crosshatches.

4 Use , , or to move the red cross in the center

to match it to the green cross.Red

• When adjusting convergence, always start at the center of the screen.

•Four lines surrounding a crosshatch indicate the point being adjusted. The color of these surrounding lines indicates the color being adjusted.

53