Marantz PV6111W manual Timer/Clock

TIMER/CLOCK (Continued)

POWER DTV VCR/ DVD/

STB TV CATV

PERSONAL PREFERENCE

A B C D

	ENTER
VOL	CH
	MENU
	AV MODE
	MUTE
	INPUT

■AUTO CLOCK SETTING

5	Use	or		to select “ON”		:CLOCK SET
	and then press				to display	AUTO
			ENTER			XDS CH
	the XDS CH screen.					ANT-A
						ANT-B		SELECT
								ENTER
								BACK
							MENU	EXIT
6	Press	or			, select	:CLOCK SET
	“AUTO”, “ANT-A” or “ANT-B” and
						AUTO
						XDS CH
	then press	ENTER .				ANT-A
						ANT-B		SELECT
								NEXT
								BACK
							MENU	EXIT

			ANT-A/B
			DISPLAY
		ENT. FLASHBACK
	TWIN		Q-SOUND
	PICTURE
CH			VIEW
			MODE
INPUT			TITLE
	REW		FF
CH/SKIP	PAUSE	STOP	REC
	DDFC		VCR/DVD
			POWER

AUTO: XDS CH (This function will automatically register the time from the extended channel).

ANT-A: This function will automatically register the time from the channel that is connected to ANT-A.

ANT-B: This function will automatically register the time from the channel that is connected to ANT-B.

• It is recommended that the “AUTO” function is utilized.

Note

XDS is information provided by television programs which contains program rating data, program Start and End times, and Time of Day

If you decide to select “ANT-A” or

7 “ANT-B”, press ENTER and then, select the channel number by

using , , and then press ENTER .

•The following message will appear after having selected the AUTO CLOCK function.

THE CLOCK IS AUTOMATICALLY SET WHEN THE UNIT IS TURNED OFF.

information. This XDS data determines whether or not parental block settings will effect the program or channel being viewed.

Turn the power off.

8 • The current time will be automatically registered.

•	If you move to another area, set the channels (See page 46 for memorizing the channels) and the clock again
Note	according to the above procedure.

•In the event that the AUTO CLOCK has still not been set, even after turning off the power for a few hours, it could be that XDS signals are not being broadcast in your area. In this case, the clock should be set manually (See page 19 for manual clock settings.)

•If the antenna signal is weak, the AUTO CLOCK function may not operate properly.

•The AUTO CLOCK will not function if there is no XDS signal broadcast.

•Select a channel that carries XDS signals with the or button.

“AIR” →	2 3	4 ………	68	69	2 ...
“CABLE-STD” →		2 3	4 ………		124	125	2 ...
“CABLE-HRC”, “CABLE-IRC” →				1	2	3 ………	124 125 2 ...

20