Operation of the Remote Control for Other Devices (Continued)
How to Identify a DTV STB (Digital TV Set-Top Box)
POWER DTV VCR/ DVD/
STB TV CATV
PERSONAL PREFERENCE
A B C D
ENTER
VOL | CH |
MENU
AV MODE
MUTE
INPUT
■To Identify Your DTV STB –Direct Entry Method
Use the following steps and the list below to quickly find the remote control code for your DTV STB.
• First look up your DTV STB’s remote code number on the list below before continuing the direct code entry steps below.
DTV/
STB
(1) Press | and the button lights. |
|
|
| |
|
| DISPLAY |
|
|
|
(2) While holding down | , press | on your remote control. | |||
| DTV/ |
|
|
|
|
Make sure STB lamp goes out and then release both buttons. | |||||
|
|
| DISPLAY |
|
|
(3) Within ten seconds after releasing | and | , enter your DTV STB’s | |||
~ | ) (refer to the list). | ||||
The code should be identified within two minutes. |
|
| |||
| DISPLAY | |
| ENT. FLASHBACK | |
TWIN | ||
PICTURE | ||
CH | VIEW | |
MODE | ||
| ||
INPUT | TITLE | |
REW | FF |
CH/SKIP 
PAUSE 
STOP 
REC
VCR/DVD
DDFCPOWER
DTV/
STB
•
lights for two seconds and then goes out. This indicates that the setting is performed successflly.
•The remote control is now ready to send commands to your DTV STB.
• | Depending on the model, year produced, brand, and type of DTV STB, some |
Note | models may not be compatible with the remote control. |
Identifying your DTV STB through the Search method
(1) While pointing the front part of the remote control towards the infrared sensor
of the DTV STB, press | DISPLAY | and hold them down for up to |
and then |
two minutes. Be careful not to let the DTV STB scan more than five channels when the indicator starts to increase. If you continue to hold down the buttons after five channel scans, the proper remote code can be passed up and the
• The remote control then searches in order for the DTV STB Brand Code
Number (listed below). | DISPLAY |
(2) At the instant when the DTV STB channel changes, release | and |
and the procedure will be completed. If a channel change does not occur on the DTV STB within two minutes, read the identifying instructions again and repeat the steps. Should a channel change still not occur, the remote will most likely not operate your DTV STB.
DTV STB BRAND | REMOTE CONTROL | |
CODE NUMBER | ||
| ||
Panasonic | 04 | |
Pioneer | 01 | |
RCA | 02 | |
Sharp | 01 | |
Sony | 03 | |
|
|
67
