Chapter 5: Hardware Installation

HARD DISK DRIVE INSTALLATION

Check to verify the hard drive’s jumper setting.

Important:

The jumper setting must be set to "master". Check the jumper setting diagram on your hard drive or consult your hard drive manual for instructions.

Note: The default setting of hard disk drive is set to “master”.

Firmly connect the ribbon cable (IDE cable) & power cable to the hard drive interface and carefully put the hard drive into the HDD rack.

Fasten the hard drive to the hard drive rack using the supplied screws.

For more information about the hard disk drive jumper settings, visit the web sites of major HDD manufacturers:

Western Digital

http://support.wdc.com/techinfo/general/jumpers.asp

Maxtor

http://www.maxtor.com/en/documentation/installation_guides/ata_installation_guide.pdf

Seagate

http://www.seagate.com/support/kb/disc/ref/jumper_settings.html

IBM http://www-3.ibm.com/pc/support/site.wss/document.do?lndocid=GSMH-3FCCKZ

Hitachi

(http://www.hgst.com/hdd/support/jumpers.htm)

Fujitsu

http://www.fujitsu.com/support/computing/storage/hdd/eol/dhdd/

12

Page 12
Image 12
Maxtor 4-Channel DVR (Digital Video Recorder) user manual Hard Disk Drive Installation