Hooking Up Your VCR
Connections to IR Emitter
Your VCR will be able to send remote control channel changing commands to your compatible cable box or satellite receiver. The VCR uses the IR Emitter to send these commands in the same way as when you use the hand held remote that came with the cable box or re- ceiver.
1Connect the supplied IR Emitter to CONVERTER BOX CONTROL on back of the VCR.
2Run the wire under or along side the cable box or satellite receiver and place the end in front of the cable box and/or satellite receiver.
IMPORTANT
If you connect both a cable box and satellite re- ceiver, place the IR Emitter to face the remote control window (sensor) in the front of both. If you cannot place it this way, you can purchase a dual IR Emitter from your Mitsubishi dealer.
3Use the double stick tape to secure the end of the emitter in the proper place.
VCR Rear Panel |
CONVERTER |
BOX CONTROL |
Cable Box or Satellite Receiver |
IR Emitter |
11
