Mitsubishi Electronics HS-HD2000U manual Timer Recording

Timer Recording

When you program both the D-VHS and analog timer recording

When you turn the VCR off, the programmed recording light will appear on the front panel display, showing that the VCR is in stand-by mode for the analog timer recording. In this mode, the D-VHS timer recording you have set may not be recorded depending on the integrated HDTV or IEEE 1394-equipped HDTV receiver that you are using. (Refer to your TV or receiver ownerÕs guide for the details.) If so, you need to press POWER on the VCR front panel once to cancel the stand-by mode when the D-VHS timer recording is activated. When you press POWER, the programmed recording light will be turned off but the VCR power will remain off. Please note that the VCR cannot activate the analog timer recording while the programmed recording light is turned off.

When the D-VHS timer recording is over, press POWER on the front panel twice to turn on the programmed recording light.

Analog (S-VHS/S-VHS ET/VHS) Timer Recording of Digital Broadcast

IMPORTANT

Be sure to connect the VCR and an integrated HDTV or an IEEE 1394- equipped HDTV receiver with an S-video/video and an audio cable to record a digital broadcast in analog format.

1Select the Front S-input in the S-VHSSet-UP menu when you connect an integrated HDTV or IEEE 1394-equipped HDTV receiver to the front panel of the VCR, or Rear S-input when you connect an integrated HDTV or IEEE 1394- equipped HDTV receiver to the rear of the VCR. See Selecting S-input Setting on page 33.

2Select the channel you would like to record on an integrated HDTV or an IEEE 1394-equipped HDTV receiver, not on the VCR.

3Load a tape with its erasure prevention tab intact into the VCR.

4Press MENU. VCR Main Menu appears on your screen. Turn the ADJUST dial to select Program to record. Turn the SHUTTLE ring to the right.

If there is at least one programmed recording already entered, you will see the Recap screen. Wait 4 seconds, and the VCR Plus+ system menu will appear.

IMPORTANT

If you have already programmed 8 recording events, Program memory is full will appear on your screen for 3 seconds, and then the Recap screen will appear. Use CANCEL to erase an entry before you can add another one.

5VCR Plus+ system menu appears. See page 42 to learn how to program with VCR Plus+ system. To pass this screen, turn the SHUTTLE ring to the right.

»VCR Main Menu￿
ÂProgram to record￿
Ä1394 connection list￿
ÃCustomize choices￿
ÈS-VHS Set-Up￿
ÄFirst Time Set-Up￿
￿ ￿
Use￿ ADJUST to select,￿
and ENTER.￿
Press MENU to exit menus
ÂProgram to record￿
CH DAY	ON	OFF￿
10 TH15	9:00a10:30pSP￿
¤--- --	--:-- --:-- SP￿

----- --:-- --:-- SP￿

----- --:-- --:-- SP￿

¹¹¹¹¹¹¹¹¹¹¹¹¹¹¹¹¹¹¹¹¹¹¹¹￿ Use ADJUST to select,￿ and ENTER.￿

Press MENU to go back.

Recap screen

ÂVCR Plus+ system￿

￿

Use number keys to enter￿ the PlusCode number￿

--------￿

￿

or press ENTER to￿ program.￿

￿

Press MENU to go back.

38