Setting Up Your VCR
Setting the Clock
If your clock is set correctly, skip this section.
If your VCR cannot set the clock automatically in the ALLSET procedure, you have to set the clock using either Setting the Auto Clock or Setting the Clock Manu- ally.
Setting the Auto Clock
Your VCR can set the clock automatically by picking up a time signal which some TV and cable channels transmit with their broadcasts. Most PBS stations send this signal; however, this function works only if a channel in your area is broadcasting a time signal. If you donÕt receive this signal, set the clock manually.
1Press MENU on the remote control. VCR Main Menu will appear.
2Turn the ADJUST dial to select First Time
3You will see the Set the clock menu. Clock set will be highlighted. Turn the ADJUST dial to select AUTO.
4Turn the VCR off to activate the auto clock setting function.
The VCR will search for a channel that carries a time signal, then set your time zone and daylight saving time. If there are only a few channels in your area that carry time signals, it may take about 30 minutes to complete. If you turn the VCR on before the correct time displays, the auto clock setting will be cancelled. See if the clock has been set on the front panel display on the VCR.
If the VCR displays the wrong time, the time zone setting may not be correct. To adjust this, follow the steps in If the VCR displays the wrong time. (See the next page.)
IMPORTANT
When you memorized channels, if you chose Cable box only or Digital cable box only, make sure you leave the cable box or digital cable box on. At 3:00 am, when the VCR power is off, the VCR will begin to automatically change channels on the cable box, one by one, to set the clock. At this time you cannot use the cable box.
If you want to use the cable box at 3:00 am, turn on the VCR or set the Clock set of the Set the clock menu to MANUAL. In both cases, auto clock function will be cancelled.
When you memorized channels, if you chose Cable or Indoor/outdoor ant., the VCR will set the clock as soon as you turn off the VCR, and at 3:00 am.
After a power failure, the VCR will automatically set the clock again. (If you have set the Clock set setting of the Set the clock menu to MANUAL, the auto clock function will not work.)
ÄFirst Time
ÅSet the clock ÇAdd/delete channels
±Sat.receiver (OFF)
¹¹¹¹¹¹¹¹¹¹¹¹¹¹¹¹¹¹¹¹¹¹¹¹ Use ADJUST to select, and ENTER.
Press MENU to go back.
|
|
|
|
|
|
|
| ÅSet the clock |
|
|
|
| |
|
|
|
|
| ||
| (AUTO) |
| ||||
| ÄClock set |
|
| |||
|
|
|
|
|
| |
|
|
|
|
| ||
| ¹¹¹¹¹¹¹¹¹¹¹¹¹¹¹¹¹¹¹¹¹¹¹¹ |
| ||||
| Use ADJUST to select, |
|
|
| ||
| and ENTER. |
|
|
|
| |
| Press MENU to go back. |
|
|
| ||
|
|
|
|
|
|
|
23
