Setting Up Your VCR
IMPORTANT
Automatic channel programming using ALLSET may include vacant channels if there are stray signals or noise on those channels. If this occurs, you can manually delete the channels using the procedure in the section Adding and Deleting Channels.
You do not need to perform this
After a power failure, if you have set Clock set within the Set the clock menu to AUTO, then ALLSET will automatically set the clock again.
Once the VCR has completed the ALLSET
Satellite Receiver Control
If you are using a satellite receiver, you can set up your VCR to change channels on the satellite receiver.
1Make sure you are viewing the picture coming from your VCR. Press MENU on the remote control. VCR Main Menu appears.
2Turn the ADJUST dial on the remote control to select First Time
3You will see the First Time
IMPORTANT
You cannot select Sat. receiver if you select Digital Cable box only in step 4 of ALLSET (on page 17).
4Turn the SHUTTLE ring to the right to select the correct code for your satellite receiver.
Manufacturer | Code |
GE | 1 |
RCA | 1, 8 |
PRIMESTAR¨ | 2 |
Sony | 3 |
DISH Network | 4 |
Toshiba | 5 |
Panasonic | 6 |
Mitsubishi/Hughes | 7 |
none | OFF |
5After you have selected, press MENU twice to exit the menus.
IMPORTANT
After you have connected the satellite receiver and set the brand code, you need to see if your VCR can control your satellite receiver. To do this, use CHANNEL or number buttons on the VCR remote to tune to a satellite channel. If the satellite channels appear on your TV, then your VCR can control your satellite receiver.
ÄFirst Time
ÅSet the clock ÇAdd/delete channels
±Sat.receiver (OFF)
¹¹¹¹¹¹¹¹¹¹¹¹¹¹¹¹¹¹¹¹¹¹¹¹ Use ADJUST to select, and ENTER to change. Press MENU to go back.
20
