Advanced Features

To program the remote control operational setting

The HS-HD2000U has two remote control operational settings, VCR-A and VCR-B. These are available so you may separately control two Mitsubishi VCRs that are placed close together. The VCR-A setting can be used to operate any other Mitsubishi VCR introduced since 1986. Setting the HS-HD2000U to VCR-B will allow the HS-HD2000U be operated without the VCR responding at the same time.

To program the HS-HD2000U and the remote to VCR-B

For VCR:

1Make sure the HS-HD2000U is plugged in but turned off. On the VCR front panel, turn the shuttle ring left while holding down SP/EP on the front panel. To confirm that the VCR responds to VCR-B signals, b appears on the front panel display.

For remote:

2On the remote, make sure the VCR/TV slide switch is in the VCR position, then press VCR-A/B on the remote control until VCR-B appears on the remote control LCD.

When you wish to operate the other VCR

SP/EP

1 On the remote, with the VCR/TV slide switch in the VCR position, press VCR- A/B on the remote control until VCR-A appears on the remote control LCD.

To reprogram the HS-HD2000U to respond to VCR-A signals again

1Make sure the HS-HD2000U is plugged in but turned off. On the VCR front panel, turn the shuttle ring right while holding down SP/EP on the front panel. To confirm that the VCR responds to VCR-A signals, A appears on the front panel display.

IMPORTANT

Some other models of Mitsubishi VCRs can respond to VCR-B signals. If your other VCR is one of these models, and you would like to program the other VCR to respond to VCR-B signals, refer to the ownerÕs guide that came with the other VCR.

Some of the buttons may not function or they may operate different features than expected for the other VCR, particularly, those Mitsubishi VCRÕs that are more than 10 years old because Mitsubishi changes the codes from time to time.

Child Lock

The child lock feature prevents others from using your VCR. To lock the VCR:

1Press and hold down DISPLAY on the remote control for about 8 seconds. The LOCK light on the front panel display will light up.

2To cancel the child lock, press and hold down DISPLAY for about 8 seconds, until the LOCK light on the front panel display goes out.

IMPORTANT

You can lock the VCR with the power off, even if the VCR is standing by for a programmed recording. If you lock the VCR with no cassette in it, the VCR will not accept a cassette.

VCR-A/B

shuttle ring

VCR-B VCR-A

LOCK light

PWR.

SP

 

 

 

 

VCR

REC

 

 

 

 

 

CH

 

LOCK

L

R

 

 

 

 

 

 

H

M

 

S

 

65

Page 67
Image 67
Mitsubishi Electronics HS-HD2000U manual Child Lock, To program the remote control operational setting