Motorola 2000X quick start Flex PC Partner, What caused my application installation to fail?

ÄIf the insufficient power is not corrected by changing the power source, the charger might be malfunctioning. Have the charger checked by an authorized service technician.

I just inserted a fresh battery, but it only lasted 2 days. Why?

When your PageWriter 2000X Two-Way Wireless Communications Center is set to two-way transmission but is not receiving Full Service (i.e., you are out of range), the pager continues to attempt to reestablish communication with the network. This acts as a continuous drain on the battery. Whenever you leave a two-way coverage zone, set the radio mode to One-way or Off to preserve the battery.

I haven’t used my pager in two months. When I place the unit in the charger, I get a flashing red light. Do I need a new battery?

Your battery is hyper-drained and it needs to be reconditioned.

1.Place the battery in the docking station. The light will blink red.

2.Let the battery sit overnight.

3.If the light is still flashing red in the morning, remove the battery and put it back into the charger.

4.Repeat procedure until the light goes green. If after three attempts the battery doesn’t charge to green, the battery can- not be reconditioned and must be replaced.

FLEX PC Partner

Why can’t I establish a connection between my pager and my PC via the infrared interface?

Check the following before re-attempting to establish a connection:

•Make sure you have opened the FLEX PC Partner application

on your pager and selected to get the Connect Status screen.

•Make sure your pager is placed properly in the docking station and that the RS232 cable and transformer are properly con- nected. For more information see “To connect the docking sta- tion to your computer:” on page 18.

•Make sure the communications port on your PC is correctly set. For more information, see “To configure FLEX PC Part- ner:” on page 56.

84 PageWriter 2000X User’s Guide

What caused my application installation to fail?

The pager may be in a Low RAM status or you may be attempting to load an application that is close in size to the available RAM. Remove the pager from the charger. Reset the pager by turning it off then back on again. Run the installation program again.

Partner stopped working during a download and is unresponsive. What should I do?

The battery might be drained of power. Replace or recharge the battery, and restart the Partner download.

Commonly Asked Questions 85