MultiModemBA User Guide
S26
Failed Password Attempts
Unit: | 1 failed attempt |
Range: | |
Default: | 0 |
Description: | S26 counts the number of times there has been a failed password attempt. For |
| example, if you entered ATS26? the message 003 would be displayed, meaning |
| someone has failed three times to gain access to your modem using its password |
| security system. |
S29
Local Inactivity Timer
Unit: | minutes |
Range: | |
Default: | 20 |
Description: | S29 defines the amount of idle time that can elapse between AT commands after the |
| SETUP password has been entered. If this timer expires, the LOGIN and SETUP |
| passwords will have to be |
| been sent a #DB1 command, which secures the modem from local and remote |
| configuration or dialing (i.e., no AT commands can be sent until the LOGIN and |
| SETUP passwords have been entered). |
S30
Inactivity Timer
Unit: | 1 min. |
Range: | |
Default: | 0 |
Description: | S30 causes the modem to disconnect if no data is transmitted or received for a |
| specified time. This timer runs during both Reliable and Normal error correction |
| connections. The timer restarts any time a data character is passed through the |
| serial port (either sent or received). If noise on the phone line causes an error to be |
| received during Normal mode, this also restarts the timer. The default value is off (0). |
| The inactivity timer is disabled by setting S30 to 0, which is the factory default |
| setting. |
S32
Time Elapse for Escape Sequence
Unit: | 1 second |
Range: | |
Default: | 20 |
Description: | S32 sets the time period to validate the escape sequence. If the time interval expires |
| before the escape sequence is employed (by hitting RETURN), the escape |
| sequence is aborted. The default is 20 units. |
S34
Buffer Length of Command Mode...After
Unit: | ASCII Character |
Range: | |
Default: | 10 |
Description: | If the number of characters after AT exceeds the S34 buffer length value, the buffer |
| is cleared and the escape sequence is aborted. |
54
