Muratec F-114P service manual ADF Rubber Pad

Disassembly and Reassembly

3.7ADF Rubber Pad

1.Before you remove the ADF Rubber Pad, you should remove:

- Rear Cover (see section 3.3) - OPE Unit (see section 3.6)

2.Insert a flat-blade screwdriver into the slot as shown below, and release the latches.

Take out the Rubber Holder and the Rubber Pad.

Rubber Pad

Rubber Holder

Note:

•When you reassemble the Rubber Pad, be sure that the Rubber Pad and Holder fit into the Guide Boss and the Holder latches fit into the corresponding holes. Then push firmly until it clicks.

•Clean the surface of the Rubber Pad with ethyl alcohol. After wiping it, be sure to dry it. Check the rubber for wear. If the wear reaches 1/2 it's original thickness, replace it with a new one.

Service Manual 3-6 Samsung Electronics