Table of Contents
AT-MIO-16X User Manual xii
©
National Instruments Corporation
Figure 5-7. Cyclic Waveform Programming ...........................................................5-27
Figure 5-8. Programmed Cycle Waveform Programming.......................................5-29
Figure 5-9. Pulsed Cyclic Waveform Programming................................................5-31
Figure 5-10. RTSI Switch Control Pattern.................................................................5-40
Figure 6-1. AT-MIO-16X EEPROM Map...............................................................6-2
Figure 6-2. Revision and Subrevision Field.............................................................6-5
Figure 6-3. Configuration Memory Depth Field......................................................6-5
Figure 6-4. ADC and DAC FIFO Depth Field.........................................................6-6
Figure 6-5. Area Information Field..........................................................................6-6
Figure B-1. AT-MIO-16X 50-Pin I/O Connector.....................................................B-2
Figure B-2. AT-MIO-16X 68-Pin I/O Connector.....................................................B-3
TablesTable 2-1. Default Settings of National Instruments Products for the PC..............2-4
Table 2-2. Switch Settings with Corresponding Base I/O Address and
Base I/O Address Space ........................................................................ 2-5
Table 2-3. Available Input Configurations for the AT-MIO-16X..........................2-8
Table 2-4. Actual Range and Measurement Precision Versus Input Range
Selection and Gain.................................................................................2-11
Table 2-5. Recommended Input Configurations for Ground-Referenced and
Floating Signal Sources.........................................................................2-22
Table 4-1. AT-MIO-16X Register Map..................................................................4-1
Table 4-2. DMA Channel Selection ....................................................................... 4-12
Table 4-3. DMA and Interrupt Modes....................................................................4-16
Table 4-4. Interrupt Level Selection.......................................................................4-19
Table 4-5. Board and RTSI Clock Selection.......................................................... 4-21
Table 4-6. Analog Output Waveform Modes......................................................... 4-22
Table 4-7. Straight Binary Mode A/D Conversion Values.....................................4-33
Table 4-8. Two’s Complement Mode A/D Conversion Values............................. 4-34
Table 4-9. Input Configuration...............................................................................4-39
Table 4-10. Analog Output Voltage Versus Digital Code (Unipolar Mode)............4-42
Table 4-11. Analog Output Voltage Versus Digital Code (Bipolar Mode).............. 4-42
Table 5-1. Am9513A Counter/Timer Allocations..................................................5-2
Table 5-2. RTSI Switch Signal Connections..........................................................5-38
Table 6-1. EEPROM Factory Area Information.....................................................6-2
Table 6-2. Calibration DACs..................................................................................6-8