N300 Wireless Dual Band ADSL2+ Modem Router DGND3300v2 User Manual
Figure 67.
The N300 wireless modem router supports two modes of the wireless repeating function, and allows you to control wireless client association:
•Wireless Repeater. The N300 wireless modem router sends all traffic from its local wireless or wired computers to a remote AP. To configure this mode, you must know the MAC address of the remote parent AP.
•Wireless Base Station. The N300 wireless modem router acts as the parent AP, bridging traffic to and from the child repeater AP, as well as handling wireless and wired local computers. To configure this mode, you must know the MAC addresses of the child repeater AP.
•Disable Wireless Client Association. Usually this check box is cleared so that the N300 wireless modem router is an access point for wireless computers.
If this check box is selected, the N300 wireless modem router communicates wirelessly only with other APs whose MAC addresses are listed in this screen. The N300 wireless modem router still communicates with
Setting Up the Base Station
The wireless repeating function works only in hub and spoke mode. The units cannot be daisy chained. You must know the wireless settings for both units. You must know the MAC address of the remote unit. First, set up the base station, and then set up the repeater.
To set up the base station:
1.Set up both units with exactly the same wireless settings (SSID, mode, channel, and security). Note that the wireless security option must be set to None or WEP.
2.Log in to the N300 wireless modem router base unit. Select Advanced > Wireless Repeating Function to display the Wireless Repeating Function screen.
