NETGEAR DGND3300-100NAS user manual Setting Up a Repeater Unit

N300 Wireless Dual Band ADSL2+ Modem Router DGND3300v2 User Manual

Figure 68.

3.Select the Enable Wireless Repeating Function check box and the Wireless Base Station radio button.

4.Enter the MAC address for the repeater units.

5.Click Apply to save your changes.

Setting Up a Repeater Unit

Use a wired Ethernet connection to set up the repeater unit to avoid conflicts with the wireless connection to the base station.

Note: If you are using the N300 Wireless Dual Band ADSL2+ Modem Router DGND3300v2 base station with a non-NETGEAR N300 wireless modem router as the repeater, you might need to change additional configuration settings. In particular, you should disable the DHCP server function on the wireless repeater AP.

To configure a N300 wireless modem router as a repeater unit:

1.If you are using the same model of N300 wireless modem router for both the base station and repeaters, you must change the LAN IP address for each repeater to a different IP address in the same subnet (see Using the LAN Setup Options on page 112).

Note: Failing to change the LAN IP address will cause an IP address conflict in the network because the factory default LAN IP is the same for both units.

128 Chapter 7. Advanced Settings (Part 1)