Nortel Networks 5399 Access Switch Hardware Installation Guide
Chapter 3 ROMMo nitor Commands
3-12
The boot –l command downloads and savesthe operational image toRAM,erases theexisting Flashmemory,copies thenew imagefrom RAMto Flash memoryin compressed form, and then executes the image.The boot –l command display looks similar to this:

After executing a boot –l,thels commandmay not show the

newly-loadedimage. If this happens, the image is not stored in

Flash memory.This indicates that you could have a problem

with your Flashmemory.

monitor:: boot –l
Enter boot file name [(ip) “oper. 64.enet”, \
(mop) “OPER_64_ENET.SYS”] ::
Waiting for CMB Config Block Info ...
Requesting default boot file “O PER_64_ENET.SYS” for \
MOP/VMS loads and “oper.64.enet ”f or all other protocols.\
Unanswered requestsshown as ‘?’,transmission errors as‘*’.
Requesting boot from 192.9.2 00.88 via Ethernet...
Booting BFS file using open delay o f 8
Booting from 192.9.200 .88
Header received OK. Received data blocks shown as ‘.’.
............................ .
..............................
....................EOF
Saving image into storage device .. .
Erasing device
|--------------------- -------------------------- ------|
...................... .......................... .......
Erase completed
Storing image ...
...................... ................
Storage completed
Beginning execution of image ...