Nortel Networks V100 Verifying Server2 application server, 120.120.13.1, At the management pc

Copyright © 2006 Nortel Networks 163

120.120.13.1

The only address in this file defines your default gateway route (your router). If this file is empty and the machine is rebooted, then you will not have network access to your other servers.

Verifying Server2 (application server)

The following commands are executed on the application server using PuTTY SSH into the machine logical IP address.

Example: Open a PuTTY SSH session to 120.120.13.25

Procedure 44 Verifying the application servers

At the management pc,

1Log into the server as nortel/<new nortel user password>

2After installing the MCS Base Platform System Software CDs 1-6, execute the following command to verify IP addressing.

[@mcsmicroapp]/export/home/nortel:=> ifconfig -a

lo0:

flags=1000849<UP,LOOPBACK,RUNNING,MULTICAST,IPv4> mtu 8232 index 1 inet 127.0.0.1 netmask ff000000

dmfe0:

flags=9040843<UP,BROADCAST,RUNNING,MULTICAST,DEP RECATED,IPv4,NOFAILOVER> mtu 1500 index 2 inet 120.120.13.23 netmask ffffff00 broadcast 120.120.13.255 groupname imspub

dmfe0:1:

flags=1000843<UP,BROADCAST,RUNNING,MULTICAST,IPv4

> mtu 1500 index 2 inet 120.120.13.25 netmask ffffff00 broadcast 120.120.13.255

dmfe1:

flags=69040843<UP,BROADCAST,RUNNING,MULTICAST,DE PRECATED,IPv4,NOFAILOVER,STANDBY,INACTIVE> mtu 1500 index 3 inet 120.120.13.24 netmask ffffff00 broadcast 120.120.13.255 groupname imspub

3Look for the entry that starts with ‘dmfe0.’ The parameters that follow show the IP address, subnet mask, and whether the interface is ‘UP.’ This example output shows that dmfe0 is assigned to IP address 120.120.13.23, its subnet mask is ffffff00 which translates to 255.255.255.0, and the interface is UP (active).

MCS 2-server Sun Fire V100 Solaris Installation and Commissioning Guide