Nortel Networks V100 Deploying the initial database load, Prerequisites, At the management pc

Copyright © 2006 Nortel Networks

Deploying the initial database load

Prerequisites

Ensure that the MCS Base Platform Software and Oracle 9i have been installed on database servers.

ATTENTION

Refer to your CSI datasheet to enter the IP addresses that you are prompted for in this section.

Deploying the MCS database load (imssipdb)

After performing the steps for installing MCS Base Platform software and Oracle software, an empty imsdb1 database is all that exists. A database load must be deployed on the database machine (Server1) to define all of the MCS schemas and configurations.

Commands are executed on each server using PuTTY SSH into the machine logical IP address (ex.: 120.120.13.25). The procedure to install the database load for the first time is command-line driven and executed from the MgmtSvr.

Example: Open a PuTTY SSH session to Server1 120.120.13.22

Procedure 21 Deploying the initial database load (imssipdb)

At the management pc,

1Log into the MgmtSvr: User name: <nortel>

Password: <your new password>

2Execute the following command: dbdeploy.pl [Enter]

3Select the correct database load and press Enter.

4Is this a Replicated Database? Enter N for a non-redundant system.

MCS 2-server Sun Fire V100 Solaris Installation and Commissioning Guide