Nortel Networks V100 manual Continuing the process, identification is completed

Copyright © 2006 Nortel Networks 51

Continuing the process

15Confirm your information. Ensure all fields are filled correctly. Press Esc+2 to continue.

Press Esc+4 if you need to change anything.

16At the Regions prompt, select the country where the system is going to be deployed. Use the arrow keys to navigate to the required country and press the spacebar to mark your choice. Ignore time zone syntax errors.

Press Esc+2 to continue.

17At the Time zones prompt, select the time zone (for example, Central for the Richardson, Texas, area) where the system is going to be deployed. Use the arrow keys to navigate to the required time zone and press the spacebar to mark your choice.

Press Esc+2 to continue. Please wait for the next prompt.

18At the Date and time prompt, set up the date and time. Press Esc+2 to continue.

19Confirm information. Ensure all fields are filled correctly.

Press Esc+2 to continue and wait for the message: System

identification is completed.

20

ATTENTION

Make the following selection very carefully. If you make a mistake at this point, you will need to start over, beginning with Powering on the servers on page 45. The selection of the number depends on the configuration type.

You will see the following message. Select the 2-server Micro

Configuration (1) option, then press Enter:

*********************************************

1)2-server Micro Configuration

2)4 or 4+ Standard Configuration

**********************************************

You will see the message Creating disk profile for standard <number of servers> server system.

MCS 2-server Sun Fire V100 Solaris Installation and Commissioning Guide