Nortel Networks V100 Sysmgr deployment verification, Procedure 23 Verifying the Sysmgr deployment

Copyright © 2006 Nortel Networks 77

Example: 120.120.13.22

7Will a Motorola SAM16 server (SIP PriGwy or SIP Audio Svr) be deployed? [Y/N]

Always answer N [Enter] even if you have a third-party gateway.

Note: Information obtained for deploying the Sysmgr appears.

8Is the above data correct? [Y] Answer Y [Enter]

9Start up the SysMgr and TSS processes? [Y] Answer Y [Enter]

Note: You must wait until the system returns to prompt since the system does a sleep message as it starts each service. There may be a delay.

Sysmgr deployment verification

After completing step 9 above, the screen will display deployment information. Notice that the script waits 30 seconds between process executions. The script is starting three processes that must be running in order to continue MCS load deployment.

The three processes can be verified by opening a PuTTY SSH session to the management / accounting server.

Example: Open a PuTTY SSH session to 120.120.13.22

Procedure 23 Verifying the Sysmgr deployment

At the management pc,

1Log into management / accounting server as nortel / <your new password>.

2Execute the following command to verify processes:

[@micromgmt] /export/home/nortel:=> meinit -p

Rel3	NTme_pids	mgmtsvr	mgmtsvr.3 xxxx
Rel3	NTme_pids	tsscma	tsscma.5	xxxx
Rel3	NTme_pids	tssfpma	tssfpma.6	xxxx

Note: The numerical value of the PIDs is shown as "xxxx" because it may vary on each system.

The results of the meinit command should display three processes along with their process ids.

MCS 2-server Sun Fire V100 Solaris Installation and Commissioning Guide