Nortel Networks V100 manual Procedure 16 Installing CD4, At the management pc

Copyright © 2006 Nortel Networks 60

Procedure 16 Installing CD4

At the management pc,

1Place CD4 in the CD-ROM drive and press Enter to continue. WAIT until you see the following statement appear:

”You are now configuring the NTP time source for this server. The servers which run the Management and Accounting service will be the source. You will need to provide the Machine Logical IP Address of each server. If running simplex mode, provide the same address twice.”

2Press Enter to continue.

3You will see the following message: "NTP Source 1: Enter the MACHINE Logical IP Address of the Management Server:

Enter the IP address, for example: 120.120.13.22

4You will see the following message: "NTP Source 2: Enter the MACHINE Logical IP Address of the Accounting Server:

Enter the IP address, for example: 120.120.13.22

5You will see the following message:

You have chosen to configure NTP as follows: Type of server: Application

NTP SOURCE (Management IP address): 120.120.13.22

NTP SOURCE (Accounting IP address): 120.120.13.22

Is the above configuration correct (y/n):

Select Y to continue or N to change.

6Wait until you see the following message:

You are now configuring IPMP (Multipathing) Please have the Application Servers (Appsvr, IPCM, WebSvr, WebClientMgr) Physical IP addresses and the Machine Logical IP address ready. Have 6 IP addresses that can be used as ping buddies. Recommendations for ping buddies are provided.

7Press Enter to continue.

8When you see the IP multipathing configuration for Sun Solaris information appear, press Enter to accept it or type in a preferred setting. The default failover timeout is set to 1000mSec.

NN10364-301 MCS 5100 3.5 Standard 6.0 December 2006