Nortel Networks V100 manual Procedure 8 Accessing the MRV LX terminal server, At the management pc

Copyright © 2006 Nortel Networks 41

4Enter a new user password at the Enter your NEW password: prompt. The password will be displayed as asterisks.

5Re-enter the new user password at the Re-Enter your NEW password: prompt. The password will be displayed as asterisks.

6To change the superuser password for the unit, do the following: a Access the Configuration Command Mode.

b Enter the password command at the Config:0 >> prompt.

c Enter a new superuser password at the Enter your NEW

password: prompt. The password will be displayed as asterisks.

d Re-enter the new superuser password at the Re-Enter your NEW password: prompt. The password will be displayed as asterisks.

Procedure 8 Accessing the MRV LX terminal server

At the management pc,

1Select Start -> Programs -> Accessories -> Communications -> HyperTerminal.exe

2 Name the HyperTerminal Session: termserv [Enter]

3Ensure that the appropriate COM port is set and that the terminal emulation is set to VT100.

Note 1: You may be asked for the following parameters:

•9600 baud rate

•8 data bits / second

•parity - None

•stop bit - 1

•Flow control - None

Note 2: Press Enter until you receive a log-in prompt. You may need to press Enter several times before the prompt appears.

4Log in to the HyperTerminal: access [Enter]

Note: The letters do not appear when you type them. You are typing them in blind.

5Enter your username: admin [Enter]

6To change security at the prompt, type set priv [Enter]

MCS 2-server Sun Fire V100 Solaris Installation and Commissioning Guide