Oki 3320, 3321 specifications Lamp Display, Printer mode display

6.3Lamp Display

(1)Printer mode display

Table 6.2

ALARM	ALARM		LED CONDITION				CONTENTS
CATEGORY		ALARM	SEL	MENU	10CPI	15CPI
	Paper end alarm	ON	OFF	—	—	—	From, cut sheet or bottom
							paper end
							Change lever is set to TOP
	Paper change	ON	OFF	—	BLINK	OFF	position while paper is
	lever alarm				1		already inserted from rear or
							bottom.
OPERATOR							• Cut sheet could not be
	Paper jam alarm	ON	OFF	—	OFF	BLINK	ejected.
ALARM						1	• Cut sheet could not be fed
							properly
	Print Head	OFF	—	BLINK	—	—	Print head temperature
	thermal alarm			1			exceeds 119°C
	Space motor	OFF	—	BLINK	—	—	Temperature of space motor
	thermal alarm			1			exceeds specified value.
FATAL ALARM		BLINK	OFF	OFF	See Table 6.3		Hardware Alarm has
		2					occurred.

TROUBLE

SHOOTING

Set New paper.

•Set the lever to specified position.

•Check rear sensor lever.

•Replace Control Board

•Remove the paper or check feed Mechanism

•Press SEL key.

•Wait until it is cooled.

•Replace P.H. or Driver Board

•It is recovered automatically

•Replace SP motor or Driver Board

See Table 6.3.

Note:

BLINK1 : 400ms ON, 400ms OFF

BLINK2 : 200ms ON, 200ms OFF

—: LED is kept in Current Condition (no change)

(2)Fault alram display

When the printer detects any of the various alarm states, the information is displayed as shown below on the operation panel. The alarm is specified by lamp combination of PRINT QUALITY and CHARACTER PITCH. (See Table 6.3 for details.)

SEL
SEL	LF	FF/LOAD	TEAR	PARK QUIET
MENU	SHIFT Micro Feed	Micro Feed		TOF
	Down	Up
EXIT	GROUP	ITEM	SET	PRINT
POWER	ALARM	MENU

PRINT QUALITY

HSD UTILITY

NLQ SSD

CHARACTER PITCH

	10	12	15
	17	20	PROP
RESET

Figure 6-1

6 – 2