Olicom 8600, 8605 manual

65

4.Verify that the power LED is on. If not, make sure the outlet is working properly. If the outlet is working, but the power LED and the fans are not on, see Chapter 10, “Troubleshooting”.

5.When the switch powers on, observe the self-test diagnostic that the unit runs for approximately 1-2 minutes. The DIAG LED is on for the duration of the test, turning off when the self-test is complete.

6.At the completion of the diagnostics, the front panel LEDs should be illuminated according to the status of the unit’s configuration. See the following sections for a description of the controls and LEDs for the switch.

➽Note: If the switch fails to power up correctly or if it encounters any unrecoverable error, the ERR LED will be on or flashing on. If the ERR LED is on or flashes, see Chapter 10, “Troubleshooting”.

➽Caution: If you are using the CrossFire 8311 redundant power supply unit, note that this unit is not hot-swappable. Both the CrossFire 8311 unit and the switch must be off before connecting or disconnecting the DC power cable.

CrossFire 8600/8605 Token-Ring Switches v. 1.2, P/N: 710001641 Installation