Onkyo TX-DS656 instruction manual Speaker system setup, Level Calibration using remote controller

Speaker system setup

POWER button

SENDING/		SUBROOM
LEARNED		A B LEARN
POWER	SLEEP DIMMER	TEST	SUR
		TONE	MODE
	SOURCE SELECTOR		MULTI-CH
DVD	VIDEO-1 VIDEO-2	VIDEO-3	INPUT
TAPE-1 TAPE-2 TUNER		PHONO	C D
PROGRAMMABLE AREA TV/ VIDEO
POWER	C H	VOLUME
POWER			TV/ VCR
		TUNER
	GROUP	PRESET
DISC	C D	TAPE
SUBTITLE	DVD
ON / OFF
	PAUSE	CH SEL
	/ STEP
CURSOR
	ENTER	LEVEL	VOLUME
		MUTING
		/ REMOTE
		SPEAKER
REMOTE CONTROLLER		RC-373M

TEST TONE button

LEVEL y/u button

Level Calibration using remote controller

You can perform level calibration (channel balance setting) independ- ent of the other speaker system settings.

In the following procedure, use the remote controller unless otherwise specified.

1.Press the POWER button.

2.Press the TEST TONE button.

Press the TEST TONE button again. A test tone is output to each

speaker in the following sequence:

Left front speaker → Center speaker → Right front speaker → Right Surround speaker → Left Surround speaker → Subwoofer

(Returns to Left front speaker)

After a few seconds, the test tone automatically travels to the next speaker.

3.While the test tone is output, adjust the output level of the speaker using the LEVEL y or u button.

The test signal stays at the same speaker while adjustment is in progress.

You can change the channel to which the test tone is output by pressing the CH SEL button.

4.Repeat step 3 to adjust the output level of all speakers.

5.When the adjustment is complete, press the TEST TONE button.

The test tone output stops.

24