Voice-Over From Still Image Status

6 4

1

23,5

1 Open the play list screen.

2 Use the cursor buttons to select the event where you want to perform a voice-over.

3 Find the location for the voice-over.

Use the operation buttons or the search dial to find a location for a voice-over and press STILL .

4 Press the A.DUB button.

This generates an A DUB PAUSE state while a still image is output at the still location.

5 Press the STILL button.

Press the STILL button again. After a 2-second auto reverse and a 2-second playback interval, sound recording starts.

Use the VR (audio volume) controls as necessary to adjust the playback sound level.

6 Press the STOP button to end the voice-over.

◆NOTE:

•When the 24PN play list format is set in setup menu No. 026 (PLY LST FMT), the audio IN and OUT points are set in 4-frame increments. If the recording starts or stops at some other points, the IN and OUT points are automatically corrected within the recording range.

•A voice-over cannot be recorded at the beginning of an event, if the auto reverse time is too short. Save at least 2 seconds for auto reversing.

List Play Using

Voice-Over From Playback Status

5

4

2 Use the cursor buttons to select the event where you

 

want to perform a voice-over.3 Press the PLAY button to start playback at a location before the voice-over.

1

4 Hold down the A.DUB button and press the PLAY
button at the voice-over location.

 

This starts the audio recording.

 

Use the VR (audio volume) controls as necessary to adjust

 

the playback sound level.

5 Press STOP button to end the voice-over.

2

3

◆ NOTE:

 

• When the 24PN play list format is set in setup menu No. 026 (PLY LST FMT), the audio IN and OUT points are set in 4-frame

1 Open the play list screen.increments. If the recording starts or stops at some other points, the IN and OUT points are automatically corrected to fall within the recording range.

Using Play List: Simplified Voice-Over 89