Panasonic DMC-LX2 operating instructions 121, Please Check the Card Data reading error

Others

[MEMORY CARD ERROR PLEASE CHECK THE CARD]

•Failed access to the card. Insert the card again.

[READ ERROR

PLEASE CHECK THE CARD] Data reading error.

Insert the card again. Make sure the card is inserted properly and then play back again.

[WRITE ERROR

PLEASE CHECK THE CARD] Data writing error.

Turn the camera off and remove the card. Then insert the card and turn the camera on again. Be sure that the camera is turned off before removing or inserting the card to avoid damage. This error may also indicate that the card is damaged.

[MOTION RECORDING WAS CANCELLED DUE TO THE LIMITATION OF THE WRITING SPEED OF THE CARD]

•When you set the [PICT.MODE] to [30fpsVGA], [30fps16:9L] or [15fps16:9H], we recommend using cards that offer 10 MB/second or higher speeds (shown on their packages and elsewhere) for best results.

•Depending on the type of Card, recording may stop in the middle.

[A FOLDER CANNOT BE CREATED]

A folder cannot be created because there are no remaining folder numbers that can be used. (P108)

Save your data to your computer, then use this unit to reformat the card. (P106)

If you execute [NO.RESET] in the [SETUP] menu after formatting, the folder number is reset to 100. (P24)

[MOTION MODE IS NOT AVAILABLE IN 3:2 ASPECT. SET THE ASPECT SWITCH IN 4:3 OR 16:9.]

You cannot record a motion picture on a card when the aspect ratio is set to []. Set the aspect ratio to either [j] or [h]. (P60)

[SELECT 4:3 TO STORE MOTION PIC. TO INT. MEMORY.]

You cannot record a motion picture on the built-in memory when the aspect ratio is set

to [j] or []. Set the aspect ratio to [h]. (P60)

[PICTURE IS DISPLAYED FOR 16:9 TV]/

[PICTURE IS DISPLAYED FOR 4:3 TV]

•The AV cable is connected to the camera. Press [MENU/SET] if you want to delete this message at once.

•Select [TV ASPECT] in the [SETUP] menu to change the TV aspect. (P25)

•This message also appears when the USB connection cable is connected to the camera only. In this case, connect the other end of the USB connection cable to a PC or a printer. (P107, 110)

[PLEASE RE-CONNECT THE PRINTER.]

•This message appears when you change

the mode dial to print mode [ ] with the camera connected to a PC. Reconnect the

printer after changing the mode from [ ] to another one and making sure that data transmission is not in progress. ([ACCESS] appears on the camera’s LCD monitor while data transmission is in progress.)

[USB MODE CHANGED. PLEASE REMOVE THE USB CABLE.]

•This message appears when you set the mode dial to a choice other than print mode

[ ] with the camera connected to the printer. Set the mode dial back to [ ] before disconnecting the USB cable.

Disconnect the cable after canceling printing.

121

VQT0Y44