Panasonic AJ-HD1400E, J-HD1400P manual 63

Error messages (continued)

Error messages (continued)

Monitor display	Description	Corrective action	VTR
			operation
E-55	If the tape has not been taken up during unloading, this error	Set the POWER switch to OFF	STOP
UNLOAD ERROR	number flashes on the display.	and then to ON again.
E-57	If the start or end processing operation is not completed, this error	Set the POWER switch to OFF
S-FF/REW			STOP
TIMEOVER	number flashes on the display.	and then to ON again.
E-59	If the cylinder motor speed is abnormally low, this error number	Set the POWER switch to OFF
DRUM ROTA TOO			STOP
SLOW	flashes on the display.	and then to ON again.
E-60	If the cylinder motor speed is abnormally high, this error number	Set the POWER switch to OFF
DRUM ROTA TOO			STOP
FAST	flashes on the display.	and then to ON again.
E-61	If the capstan motor speed is abnormally low, the error number	Set the POWER switch to OFF
CAP ROTA TOO			STOP
SLOW	flashes on the display.	and then to ON again.
E-64	If the supply reel motor speed is abnormally high, the error number	Set the POWER switch to OFF
S REEL ROTA TOO			STOP
FAST	flashes on the display.	and then to ON again.
E-67	If the take-up reel motor speed is abnormally high, the error number	Set the POWER switch to OFF
T REEL ROTA TOO			STOP
FAST	flashes on the display.	and then to ON again.
E-69	If excess torque being applied to the take-up reel motor is detected,	Set the POWER switch to OFF
T REEL TORQUE			STOP
ERR	the error number flashes on the display.	and then to ON again.
E-70	If excess torque being applied to the supply reel motor is detected or	Set the POWER switch to OFF
S REEL TORQUE	an abnormal current flowing to the current detection resistor is		STOP
ERR	detected, this error number flashes on the display.	and then to ON again.
E-71	If abnormal tension at the supply side is detected in the capstan	Set the POWER switch to OFF
CAP TENSION			STOP
ERROR	mode, the error number flashes on the display.	and then to ON again.
E-72	If abnormal tension at the supply side is detected in the reel mode,	Set the POWER switch to OFF
REEL TENSION			STOP
ERROR	the error number flashes on the display.	and then to ON again.
E-73	If the take-up reel motor has rotated in the reverse direction, this	Set the POWER switch to OFF
REEL DIR			STOP
UNMATCH	error number flashes on the display.	and then to ON again.
E-74	If excess torque being applied to the cylinder motor is detected, this	Set the POWER switch to OFF
DRUM TORQUE			STOP
ERROR	error number flashes on the display.	and then to ON again.
E-78	If a problem has been encountered in communication between the	Set the POWER switch to OFF
	servo microcomputer and mechanism relay board, this error number		STOP
M-IF COMM ERROR	flashes on the display.	and then to ON again.
E-bA	This appears when the input DC voltage has dropped below the	Check the output voltage of the
		equipment supplying DC	STOP
BATTERY	undercut voltage.
		power.

<Note>

Consult your dealer if the error message display persists even after the unit has been restarted.

63