Remote Operation (KX-FP155 only)
Other remote operations
■Erasing a specific message
Press *4while listening to the message you want to erase.
Voice guide example:
The message has been erased.
●A long beep will sound. The unit will then play back the next message.
■Erasing all the messages
Press *5to erase all the messages.
All messages have been erased.
●A long beep will sound.
■Monitoring the room (Australian users only)
Press 6to monitor the sound for about 30 seconds in the room where the unit is installed.
●After 30 seconds, a beep sounds. To continue monitoring, press 6again within 10 seconds.
■Recording a marker message
You can leave an additional message.
1.Wait for the voice guide.
All messages have been played.
2.Wait about 10 seconds.
Please leave your name and message after the beep.
3.Leave a message after the beep.
■Re-recording a greeting message
You can change the contents of the greeting messages for TAD/FAX mode.
1.Press 7to start recording.
●A long beep will sound.
2.Speak clearly up to 16 seconds.
●If you pause for over 2 seconds, 6 beeps will sound and the recording will stop. Repeat from step 1 within 10 seconds.
3.When finished recording, press 9.
●The new greeting message will be played.
■Skipping the greeting message
Press 0during the greeting message playback.
● The unit will skip the rest of the greeting message.
■Turning the message transfer on or off
You must
Press 81to turn ON the message transfer.
Message transfer is set.
Transfer phone number is 123···.
Press 82to turn OFF the message transfer.
Message transfer is off.
●If a transfer telephone number is not programmed, you cannot turn this feature ON.
Transfer phone number is not set.
■Turning the pager call on or off
You must program a pager number beforehand (feature #70 on page 70).
Press 83to turn ON the pager call.
Pager call is set.
Pager number is 098765432.
Press 84to turn OFF the pager call.
Pager call is off.
●If a pager number is not programmed, you cannot turn this feature ON.
Pager number is not set.
■Changing the receive mode
Press 80to change the receive mode from TAD/FAX to TEL.
●You cannot return to TAD/FAX mode in the same call. To return to TAD/FAX mode, see below.
■Returning to the TAD/FAX mode
1. Call your unit and wait for 10 rings.
●You will hear a beep signal.
2.Enter the remote operation ID (feature #11 on page 63) within 8 seconds.
●You will hear a beep signal.
3.— To return to the TAD/FAX mode:
Wait for 3 seconds, then the greeting message will be played.
—To return to the TEL/FAX mode: Press #within 3 seconds.
—To return to the TEL/FAX mode: Press *within 3 seconds.
Note:
●Enter the remote operation ID within 8 seconds after hearing the beep, otherwise the call will be interrupted and the unit will remain in the TEL mode.
55
