Useful Telephone Settings
31
Helpline Tel. No.: U.K. 08700 100 076 R.O.I. 01289 8333
Base unit settings
Adjusting ringer volume
1Press $ (centre of joystick).
2Select u, then press ,.
3Enter “0000” (default base unit PIN).
LIf you changed the PIN, enter it (page
32).
4Press , 2 times.
5Push the joystick up or down repeatedly
to select the desired volume.
6Press ,.
7Press {ih}.
Call Options
Changing the recall mode
Change the recall mode, if necessary,
depending on the requirements of your
service provider or PBX.
Important:
LIf this unit is connected to a PBX, an
optional earth relay may need to be
installed. Please consult our Panasonic
Customer Care Helpline for more
information. After installation you may
select flash or earth mode to suit the
requirements of your PBX or service
provider.
1Press $ (centre of joystick).
2Select u, then press ,.
3Enter “0000” (default base unit PIN).
LIf you changed the PIN, enter it (page
32).
4Select “Call Option”, then press
, 2 times.
5Select the desired setting, then press
,.
LIf “Flash” is selected, next select
flash type 1, 2, or 3, then press ,.
“Type 1”: 700 ms
“Type 2”: 80 ms
“Type 3”: 400 ms
6Press {ih}.
Setting pause length
Change the pause length, if necessary,
depending on the requirements of your
service provider or PBX.
“Short”: 3 sec.
“Long”: 5 sec.
1Press $ (centre of joystick).
2Select u, then press ,.
3Enter “0000” (default base unit PIN).
LIf you changed the PIN, enter it (page
32).
4Select “Call Option”, then press
,.
5Select “Pause Time”, then press ,.
6Select the desired setting, then press
,.
7Press {ih}.
Storing/changing emergency numbers
These settings determine which phone
numbers can be dialled while the call bar
feature is on (page 27).
1Press $ (centre of joystick).
2Select u, then press ,.
3Enter “0000” (default base unit PIN).
LIf you changed the PIN, enter it (page
32).
4Select “Call Option”, then press
,.
5Select “Emergency Call”, then press
,.
6Select a memory location, then press
,.
LIf the memory location already
contains an emergency number, the
number is displayed.
7Enter/edit the number, then press ,.