Panasonic KX-TG2388 operating instructions Programming via direct commands

Programmable Settings

Main menu	Sub-menu 1	Sub-menu 2	Page
Initial setting	Set answering	Number of rings	54
		Recording time	54
		Remote code	54
		Recording mode	55
	Message alert	—	55
	LCD contrast	—	41
	Key tone	—	42
	Auto talk	—	43
	Caller ID edit	—	42
	Set tel line	Set dial mode	15
		Set flash time	43
		Set line mode	43
	Set base unit	Ringer tone	40
		Incoming call.	40
		Talk Caller ID	41
	Change language	—	14

Programming via direct commands

You can also program features using “direct commands”—special codes that take you directly to the feature you wish to program and allow you to select the desired setting. There is no need to scroll through the unit’s menus.

Details of each feature can be found on the corresponding pages.

Important:

L Before programming, make sure the handset and base unit are not being used. The handset must be operated near the base unit and while off the base unit or charger.

1

2

3

4

5

Press {MENU}.

Enter the desired feature code (page 37).

Enter the desired setting code (page 37).

L This step may vary depending on the feature being programmed.

Press {Save}.

Press {OFF} to exit programming mode.

Note:

L If you make a mistake or enter the wrong code, press {OFF} then start again by pressing {MENU}.

36For assistance, please visit http://www.panasonic.com/consumersupport