Programmable Settings
2 Scroll to “Accessibility” by pressing {V} or {^}, then press {Select}.
3 Scroll to “Hearing Aid Mode” by pressing {V} or {^}, then press {Select}.
4 Select “Telecoil” or “Off” by pressing {V} or {^}.
5 Press {Save}, then press {OFF}.
Note:
L When “Telecoil” is selected, “[HA]” is displayed after you press {C}.
Talk
00-00-32 [HA]
L If “Telecoil” is selected, the battery operating time will be shortened (page 10).
L If “Telecoil” is selected, the cordless handset receiver may feel warm during use. This is normal.
Re-registering the handset
If “No link to base. Move closer to base, try again.” is displayed even when the handset is near the base unit, you may need to
Important:
L Make sure the base unit is not being used.
L Have the handset and base unit near each other when
L Follow steps 1 and 2 listed below. You have about 1 minute to complete them.
1 Base unit:
Press and hold {LOCATOR/ INTERCOM} until a beep sounds.
L The CHARGE indicator flashes.
2 Handset:
Press and hold {FLASH/CALL WAIT}
until “Handset Registering” is displayed.
L When registration is complete, a beep sounds from the handset.
L Wait for 20 seconds after registration is complete while the handset establishes communication with the base unit.
Note:
L If the handset beeps 3 times and “Error!!” is displayed, an error occurred. Try again from step 1.
L You can stop registration by pressing {OFF} on the handset, and pressing {LOCATOR/INTERCOM} on the base unit.
For assistance, please visit http://www.panasonic.com/consumersupport | 45 |
