About your projector | About your projector |
Remote control |
|
■■Top |
|
Remote control signal transmitter
Send remote control signal.
Point at the remote control receiver part on the projector when using.
■■Front
With the <MAIN POWER> switch of the projector turned <ON>, switch between the standby mode and projection mode.
Cycle through the [PICTURE MODE].
Display the [VIERA LINK] menu.
Display the menu screen.
Display menus of external devices when using VIERA Link.
Alter the points during a gamma adjustment.
Switch the input signals.
Attention
Switch the remote control button lights off or on.
Display the [PICTURE] menu or [ADVANCED MENU] menu.
Display the [MEMORY
LOAD] menu.
Display the input waveform.
Display the [ECO MANAGEMENT]
menu.
Reset adjusted menu values to the default settings.
Use for menu screen operation.
Allocate frequently used operations and use as a shortcut button.
Inserting and removing the remote control batteries
Open the cover. | Insert the batteries and | ● Follow the reverse |
| replace the cover (insert | procedure to remove the |
| from side). | batteries. |
Introduction
zzDo not drop the remote control.
zzAvoid contact with liquids or moisture.
zzDo not attempt to disassemble or modify the remote control.
Note
zzPressing buttons on the remote control when button lights is set to on illuminates the button lights.
Button lights dim if no actions are carried out after approximately 5 seconds, and then extinguish if no actions are carried out after a further 5 seconds.
zzWhen pointed directly at the receiver on the front of the projector, the remote control can be used up to a distance of approximately 7 meters. It may also be used at a vertical/horizontal angle of up to ±30 degrees.
zzThe remote control may not operate correctly if there is an obstacle between it and the receiver on the projector. Signals from the remote control can be reflected off a screen when using the projector, but limitations to the range of operability may occur due to reflected light loss resulting from the properties of the screen.
zzThe remote control may not be usable if the receiver is exposed to fluorescent or other strong lights. As far as is possible, keep the remote control away from light sources.
ENGLISH - 17