Settings

[OPTION] menu

zzInput

[POWER ON/OFF]

[BLANK]

 

 

•• [POWER ON/OFF]

If the trigger input signal from the external device is changed from 0 V to 12 V, the projector power will be switched on. And if it is changed from 12 V to 0 V, the power will be switched off.

•• [BLANK]

If the trigger input signal from the external device is changed from 0 V to 12 V, the screen will go blank. And if it is changed from 12 V to 0 V, the [BLANK] setting

will be released.

3333 Press the ▲▼◄► buttons to move the cursor to [DELAY TIME]

4444 Press the ◄► buttons to set the delay time for the trigger output signal

zzThe delay time can be set to 2, 4, 6, 8, 10, 20, and 30 seconds.

zzIt is possible to delay the trigger output signal (12 V) by the amount of time set. (Only available if trigger output item is selected.)

E.g.) Select [SELECT 4:3 ASPECT] of the trigger output function and set the delay time to 10 seconds.

Set the [ASPECT] in the [POSITION] menu to [4:3], and 12V is output from the trigger port after 10 seconds.

Note

zzYou should not use trigger terminal output as the power source for other devices.

zzThe projector will not accept trigger input while preparing to project after the power has been switched on and while preparing to shutdown after projection. Input trigger signals after projection starts or after entering standby mode.

zz12 V cannot be output from the trigger terminal when the projector is in standby mode.

[HIGH ALTITUDE MODE]

Set to [ON] when using at locations between 1400 m and 2 700 m above sea level.

Switch settings

Switch settings

 

 

[OFF]

When using at an altitude of less

than 1 400 m above sea level

 

When using at high altitudes

[ON] (between 1 400 m and 2 700 m above sea level)

Note

zzThe fan rotation and operating noise increases if set to [ON].

[LAMP POWER]

Switch the lamp intensity according to the usage environment of the projector and its intended use.

Switch settings Switch settings

[NORMAL]

When higher luminance is

required

 

[ECO]

When lower luminance is

sufficient

 

Note

zzThe brightness in the [ECO] settings is lowered enabling saving power and reducing operating noise. It is recommended that you use the [ECO] setting when viewing in a place where natural light is blocked and there is no artificial light.

zzWhen no input signal is detected, the function is disabled.

66 - ENGLISH