TEMP and LAMP IndicatorsTEMP and LAMP Indicators
Managing the indicated problems
If a problem should occur with the projector, the lamp indicator <LAMP> and/or temperature indicator <TEMP> will illuminate or flash. Check the indicator status and deal with problems as follows.
Attention
zzWhen switching off power to deal with problems, ensure that you follow the procedure in “Switching off the power”. ( page 29)
Note
zzCheck the status of the power supply with the power indicator <ON (G)/STANDBY (R)>. ( page 27)
 Temperature indicator | Lamp indicator |
|
| |
■■Temperature indicator <TEMP> |
|
| ||
|
|
|
|
|
Indicator | zzIlluminates red during projection. |
|
| |
(Alert indicating [REFER TO THE “TEMP indicator” SECTION IN THE OPERATION MANUAL.] is | ||||
status | displayed.) |
|
|
|
| zzFlashing red when power is turned off (projection stops automatically). | |||
Problem | The temperature inside and/or outside the projector is abnormally high. | |||
|
|
|
|
|
| The air intake and | The room | The air filter unit | The projector may be being |
Cause | may be excessively | |||
exhaust ports may | temperature may | dirty and ventilation | used at high elevations (1 400 | |
| be obstructed. | be too high. | may be poor. | m or more above sea level). |
|
|
|
| |
|
|
|
|
|
|
| Place the projector |
| The projector can only be |
| Remove object(s) | in an environment |
| used for two minutes after |
Solution | from the ventilation | with temperature | Clean or replace | turning on. Set [HIGH |
ports or clear the | and humidity as | the air filter unit. | ALTITUDE MODE] to [ON] | |
| area around the | designated in the | ( page 73) | within two minutes of turning |
| projector. | specifications. |
| the projector on. |
|
| ( page 90) |
| ( page 66) |
|
|
|
|
|
Note
zzIf the <TEMP> indicator is illuminated or flashes despite taking the actions above, please contact your dealer to have your projector repaired.
Maintenance
ENGLISH - 71