Power cord
Use the power cord included to prevent removal of the power cord and make sure it is fully inserted into the projector.
Make sure the <MAIN POWER> switch is on the <OFF> side before connecting the power cord. Use the power cord included and ensure that it is fully inserted.
For power cord handling details, see “Read this first!”. ( pages 6 to 12)
■■Connecting | ■■Disconnecting |
Fully insert until the tabs on the left and right make a click sound.
Pull out while pushing on the tabs on the sides.
Power indicator
The power indicator indicates the power status. Check the status of the power indicator <ON (G) / STANDBY (R)>
before operating the projector.
Power indicator
Indicator status |
|
|
|
| Status | ||
|
|
|
|
|
| ||
No illumination or flashing | Main power is switched off. | ||||||
|
|
|
|
|
|
| |
|
| Power is switched off. (Standby mode.) | |||||
| Lit | Press the power < |
| / > button to start projection. | |||
|
| ||||||
|
| ||||||
Red |
| * Does not operate when the lamp indicator or temperature indicator is flashing. | |||||
|
|
|
|
|
| ||
| Power is switched off (standby mode) and the [POWER ON LINK] is set to | ||||||
|
| ||||||
| Flashing | [ON] in the VIERA Link settings. | |||||
|
| For details about [POWER ON LINK], see [POWER ON LINK] ( page 69). | |||||
| Flashing | The projector is preparing to project. | |||||
Green | Projection starts after a brief pause. | ||||||
| |||||||
| Lit | Projecting. | |||||
|
|
|
|
|
|
| |
| Lit | Preparing to switch off the power. | |||||
| The power is switched off after a while. (Changes to the standby mode.) | ||||||
Orange |
| ||||||
|
|
|
|
|
| ||
Flashing | The power < |
| / > button is switched on again in the power off preparation | ||||
|
| ||||||
|
| ||||||
| mode. Preparing to project. Projection starts after a brief pause. | ||||||
|
| ||||||
|
|
|
|
|
|
| |
Basic Operation
ENGLISH - 27