[WAVEFORM MONITOR]
By using a commercial test disk etc. and setting the luminance level of the output (brightness) signal from a connected external device to a value within this projector’s recommended range, you can perform adjustment so the display performance of the projector can be fully leveraged.
1111 Press the <ENTER> button.
zzThe [WAVEFORM MONITOR] menu is displayed.
2222 Press the ▲▼ buttons to select the required item.
zzThe waveform monitor is displayed.
zzSelect [OFF] to close the waveform monitor.
3333 Press the <ENTER> button.
Note
zzFor details, see “Displaying the waveform monitor” in “Remote control operation”. ( page 32)
■■[MONITOR POSITION]
You can set the display position of the input waveform during the FULL SCAN display.
Switch settings 
Switch settings
[PICTURE] menu
■■[AUTO ADJUST]
The luminance level of the output signal from a connected external device is automatically adjusted by setting the automatic waveform adjustment items.
1111 Press the <ENTER> button.
2222 Press the ▲▼ buttons to select the required item.
Automatic waveform | Default |
adjustment items | setting |
[BLACK LEVEL ADJUST] | [ON] |
[WHITE LEVEL ADJUST] | [ON] |
[RGB ADJUST (BLACK)] | [OFF] |
[RGB ADJUST (WHITE)] | [OFF] |
3333 Press the ◄► buttons to switch adjustment.
4444 Press the ▲▼ buttons to select [START AUTO ADJUST] and press the <ENTER> button.
zz[PROCESSING] message is displayed. When adjustment is complete, a confirmation message for applying results is displayed.
5555 Select [OK] with the▲▼ buttons.
6666 Press the <ENTER> button.
Note
zzWhen [BLACK LEVEL ADJUST] is [ON], the display signal Y (brightness) value’s black level is automatically adjusted to the 0% position.
zzWhen [WHITE LEVEL ADJUST] is [ON], the display signal Y (brightness) value’s white level is automatically adjusted to the 100% position.
zzWhen [RGB ADJUST (BLACK)] is [ON], the display signal R (Red), G (Green), and B (Blue) value’s black level are all automatically adjusted to the 0% position.
zzWhen [RGB ADJUST (WHITE)] is [ON], the display signal R (Red), G (Green), and B (Blue) value’s white level are all automatically adjusted to the 100% position.
zz[AUTO ADJUST] cannot be executed if the [WAVEFORM MONITOR] is [OFF].
zzProject the luminance adjustment signal of a commercial test disk etc., and perform automatic adjustment. However, even with an adjustment disk, correct adjustment may not be possible if noise is included on the disk itself or the playback device generates noise.
zz[AUTO ADJUST] adjusts based on the 0% and 100% standard signal within the screen, so correct adjustment cannot be performed if standard signals are not displayed on the screen because of overscan etc., or if a signal that is less than 0% or greater than 100% is displayed on the
screen.
Settings
ENGLISH - 39