Settings

[POSITION] menu

[WSS]

In the European broadcasting system, if the input signal contains an identification signal, WSS automatically switches the aspect ratio to the required setting. ( page 56)

Switch settings Switch settings

[ON] Switch automatically

[OFF] Do not switch automatically

Note

zzAspect ratio switches only in the case of these input signals: PAL/625i (576i)/625p (576p)

[OVER SCAN]

If the 4 edges of an image are partly dropped, you can use this function to adjust and project it properly.

Shrink image Enlarge image

zzSetting range: 0 to +10

Note

zzCOMPUTER signal (exc. movie based signals) is not supported.

[KEYSTONE]

If the projector is aligned non-perpendicularly to the screen, or if the projection screen has an angled surface, you can correct the keystone vertically.

ImageOperation

zzSetting range: −32 to +32

Note

zzYou can correct the distortion ± 30 degrees from the vertical plane. However, if there is overcorrection, the image quality may deteriorate and become blurry. For a better quality image, installing the projector with minimum distortion is recommended.

zzThe result of the keystone correction will affect the size of the image.

zzKeystone correction does not function on the menu screen.

zzWhen adjustment with [KEYSTONE] carried out, the vertical center of the screen and the lens need to be realigned.

zzSome distortion may occur due to lens shift adjustment. zzThe result of the keystone correction may affect the

aspect ratio.

[AUTO SETUP]

(COMPUTER IN only)

When you select [AUTO SETUP] and then press the <ENTER> button, [H-POSITION], [V-POSITION], [DOT CLOCK], and [CLOCK PHASE] are adjusted automatically in accordance with the input signal.

58 - ENGLISH