Panasonic PT-D7700U, PT-DW7000U manual Registration of input signal data, Registration of new data

Registration of input signal data

The input signal data must be registered because it is not registered on shipment of the projector.

Registration of new data

When a new signal is supplied, press the “MENU” button on the remote control or operating section of the main unit. When its data has been registered, the MAIN MENU screen is displayed.

Note • The data of 96 input signals can be registered.

•The signals supporting the installed input module are input and their data registered.

•The memories are numbered over 12 pages (A to L: 8 data items can be registered on each page), and the data is registered in the unused memory with the lowest number. If all the memories are used, the data of the old signals is overwritten in sequence.

•The names of the registered data are automatically determined by the input signals and memory numbers.

Renaming the registered signals

MAIN MENU

PICTURE

POSITION

ADVANCED MENU

LANGUAGE

OPTION

TEST PATTERN

SIGNAL LIST

SECURITY

:MENU SELECT

ENTER:SUB MENU

REGISTERED SIGNAL LIST

A1:SVGA72-A1	RGB1	– – –
A2:SVGA72-A2	RGB1	– – –
A3:SVGA72-A3	RGB1	– – –
A4:SVGA72-A4	RGB1	– – –
A5:SVGA72-A5	RGB1	– – –
A6:SVGA72-A6	RGB1	– – –
A7:SVGA72-A7	RGB1	– – –
A8:SVGA72-A8	RGB1	– – –
:SELECT	ENTER:DETAILS	STD:DELETE

REGISTERED SIGNAL STATUS

NAME:	SVGA72-A2
MEMORY NO:	A2
S.S.NO:	– – –
INPUT NO:	RGB1
fH:	48.08kHz
fV:	72.17Hz
SYNC. STATE:	H(POS)
	V(POS)

ENTER:CHANGE NANE

Press the “MENU” button.

The MAIN MENU screen will be displayed.

Select “SIGNAL LIST” with the and buttons.

Press the “ENTER” button.

The REGISTERED SIGNAL LIST screen will be displayed. The memories extend over 12 pages (A to L with 8 data items each, giving a total of 96 memories).

Select the signal whose details are to be displayed with the , , and buttons.

Press the “ENTER” button.

The REGISTERED SIGNAL STATUS screen will be displayed.

Note • The data items including the input signal name, memory number, signal selector input number, input terminal, frequency and sync signal are automatically identified and displayed.

•When the “MENU” button is pressed, the REGISTERED SIGNAL LIST screen is restored.

44