Panasonic PT-DW7000U, PT-D7700U Adjusting the color temperature, Operation Adjustment Remarks

Adjusting the color temperature

Adjustment procedure (to be performed while projecting the signals to be adjusted)

MAIN MENU

PICTURE

POSITION

ADVANCED MENU

LANGUAGE

OPTION

TEST PATTERN

SIGNAL LIST

SECURITY

PICTURE

PICTURE MODE	DYNAMIC
COLOR	50
TINT	30
COLOR TEMP.	DEFAULT
GAMMA	2.2
CONTRAST	32
BRIGHT	32
SHARPNESS	6
NOISE REDUCTION	2
DYNAMIC IRIS	1

:MENU SELECT :CHANGE

Press the “MENU” button.

The MAIN MENU screen will be displayed

Select “PICTURE” with the buttons.

Press the “ENTER” button.

The PICTURE screen will be displayed.

Select “COLOR TEMP.” with the buttons.

Select the desired setting from below

with the buttons.

“LOW”, “MIDDLE”, “HIGH”, “DEFAULT”, “USER1” and “USER2”

WHITE BALANCE

WHITE BALANCE HIGH

WHITE BALANCE LOW

WHITE BALANCE HIGH

R	255
G	255
B	255

<To further adjust toward the desired white balance>

Select “USER1” or “USER2” in Step .

Press the “ENTER” button.

Select “WHITE BALANCE HIGH” or “WHITE BALANCE LOW” with the buttons.

Press “ENTER” button.

The WHITE BALANCE HIGH (LOW) screen will be displayed.

Select “R”, “G” or “B” with the buttons.

Adjust the level with the buttons.

Item	Operation		Adjustment	Remarks
	Press	button
R (Red)			Deepens red.
	Press	button	Weakens red.
	Press	button
G (Green)			Deepens green.	Maximum value 255
				Minimum value 0
	Press	button	Weakens green.
	Press	button
B (Blue)			Deepens blue.
	Press	button	Weakens blue.

Note • All colors will not be displayed properly unless adequate adjustment is made.

If the adjustment is not successful, press “STD” (standard) button when the individual adjustment screen is displayed to restore the factory default setting only for the displayed item.

•The color temperature cannot be adjusted for the internal test pattern (refer to page 85). Be sure to project the input signal when adjusting the color temperature.

•When any setting other than “OFF” has been selected for color matching, the COLOR TEMP. setting is fixed at “USER1”

•“DEFAULT” cannot be selected when the picture mode has been set to “USER”

55