Panasonic PT-DW7000U, PT-D7700U manual Control commands, Cable specifications, Command

Control commands

When controlling the projector from a computer, the following commands are available:

Command	Function of command			Remarks
PON	Power “ON”	In standby mode, commands other than “PON” are invalid.
		• While the lamp is ON and being controlled, a “PON” command will not be accepted.
POF	Power “OFF”
I I S	Switch input modes	Parameter
		VID = VIDEO		SVD = S-VIDEO
		RG1 = RGB1		RG2 = RGB2 AUX=AUX
	Query for active	Parameter		“SINGLE” will use the
		0	= DUAL
QSL	lamp mode			lamp (LAMP 1 or LAMP 2) with
		1	= SINGLE
				shorter operating hours.
		2	= LAMP 1
		3	= LAMP 2
		Parameter
LPM	Active lamp mode	0	= DUAL
		1	= SINGLE
		2	= Only LAMP 1 is on
		3	= Only LAMP 2 is on
OLP	Lamp power setting	Parameter
		0 = HIGH, 1= LOW
Note • If you need a detailed command list, please contact your dealer.

Cable specifications

<Connecting to a PC>				Computer
	Projector		(DTE specifications)
			NC
	1	NC		1
	2			2
	3			3
			NC
	4	NC		4
	5			5
			NC
	6	NC		6
	7			7
	8			8
			NC
	9	NC		9

Attention • To connect the computer to the SERIAL terminal, prepare an adequate communication cable that fits to your personal computer.

83