Panasonic PT-DW7000U Edge blending adjustment, Specify the area to be adjusted with the buttons

Edge blending adjustment

This projector has the function to hide the seams for multi-screens.

Procedure of adjustment

MAIN MENU

PICTURE

POSITION

ADVANCED MENU

LANGUAGE

OPTION

TEST PATTERN

SIGNAL LIST

SECURITY

ADVANCED MENU

DIGITAL CINEMA REALITY AUTO

FORMATSMPTE

BLANKING

INPUT RESOLUTION

CLAMP POSITION

EDGE BLENDING ON

SYNC.TERM75

RASTER POSITION

:MENU SELECT
:CHANGE	ENTER:SUB MENU

Press the “MENU” button.

The MAIN MENU screen will be displayed.

Select the “ADVANCED MENU” with

the buttons.

Press the “ENTER” button.

The ADVANCED MENU screen will be displayed.

Select “EDGE BLENDING” with the

buttons.

Select “OFF”, “ON” or “USER” with the buttons.

OFF: When the multi-screens are not going to be used.

ON: When the tilting inside the unit is to be used for the tilting of the edge blending area.

USER: When a specific tilting is to be used for the tilting of the edge blending area. (Separate software is required to establish these settings. Consult your dealer.)

EDGE BLENDING

UPPER	START	0
OFF	WIDTH	128
LOWER	START	0
OFF	WIDTH	128
LEFT	START	0
OFF	WIDTH	128
RIGHT	START	0
OFF	WIDTH	128
MARKER		OFF
BRIGHT ADJUST

:MENU SELECT

:ADJUST ENTER:CHANGE

The optimal point is where these lines overlap.

Note

Press the “ENTER” button.

The EDGE BLENDING screen will be displayed.

Specify the area to be adjusted with the buttons.

To joint the top: set “UPPER” to “ON”.

To joint the bottom: set “LOWER” to “ON”.

To joint the left: set “LEFT” to “ON”.

To joint the right: set “RIGHT” to “ON”.

Press the “ENTER” button to toggle “ON” and “OFF”.

Adjust the compensation width and

start position with the buttons.

<To display the adjustment marker>

Select “MARKER” with the buttons.

Select “ON” with the ENTER buttons.

(Continued on next page)

Red line Green line Green line Red line

Adjustment marker

When the “MARKER” is set to “ON”, the image position adjustment marker is displayed.

The optimal point is the position where the red line of one frame overlaps the green line of the other frame.

Notice:

The correction widths of the jointed frames must be the same value all the time.

The optimal joint cannot be achieved if the jointed frames have different correction widths.

65