Panasonic PT-D7700U, PT-DW7000U manual Sharpness / Gamma / Noise reduction, Procedure of adjustment

Adjusting the picture

Sharpness / Gamma / Noise reduction

Procedure of adjustment

MAIN MENU

PICTURE

POSITION

ADVANCED MENU

LANGUAGE

OPTION

TEST PATTERN

SIGNAL LIST

SECURITY

PICTURE

PICTURE MODE	DYNAMIC
COLOR	50
TINT	30
COLOR TEMP.	DEFAULT
GAMMA	2.2
CONTRAST	32
BRIGHT	32
SHARPNESS	6
NOISE REDUCTION	2
DYNAMIC IRIS	1

:MENU SELECT :ADJUST

Press the “MENU” button.

The MAIN MENU screen will be displayed.

Select “PICTURE” with the buttons.

Press the “ENTER” button.

The PICTURE screen will be displayed.

Select desired one of the items in the

following table with the buttons.

Switch the setting with the buttons.

Refer to the following table for the items and the details.

Adjustment items	Operation		Adjustment
			0 to 7 for the RGB system and the HD system
Sharpness	Sharpens the outline of the image.		(factory setting is 2)
			0 to 15 for the SD system (factory setting is 6)
			5 settings: DEFAULT, USER1, USER2, 2.2 and
Gamma selection	Switches the gamma modes		2.5
			(factory setting: DEFAULT)
Noise reduction	Switches the noise reduction effect	Four types: OFF (no correction), 1 (low),
	mode.	2 (middle), 3 (high) (factory default: 2)

Note • Noise reduction cannot be adjusted with analog RGB input, DVI input or network input.

•Separate software is required to select “USER1” and “USER2” as the gamma setting. Consult your dealer.

To display pictures complying with the sRGB standard

sRGB is the international color reproduction standard (IEC61966-2-1) established by IEC (International Electrotechnical Commission).

To reproduce colors more faithfully in compliance with the sRGB standard, perform the following setting procedure.

1.Set color matching adjustment to “OFF”.

2.Press the buttons on the “PICTURE” menu and select the “PICTURE MODE”.

Set to “NATURAL” with the buttons.

3.Select the “COLOR” with the buttons.

Press the STD (standard) button on the remote control to restore the factory default. Follow the same procedure to restore the factory default for “TINT”, “COLOR TEMP.” and “GAMMA”.

Note • sRGB is only enable when RGB signals are being input.

56