Chapter 4 Settings — [NETWORK] menu

7)When the confirmation screen is displayed, press qw to select [OK], and press the <ENTER> button.

Note

ff The projector does not support 10BaseT Full/Half.

When the projector is connected to a twisted-pair-cable transmitter

1)Press as to select [DIGITAL LINK SETUP].

2)Press the <ENTER> button.

ff The [DIGITAL LINK SETUP] screen is displayed.

3)Press as to select [DUPLEX(DIGITAL LINK)].

4)Press qw to switch the communication method.

ff The items will switch each time you press the button.

[100BaseTX-Full]

Full-duplex communication method is set.

[100BaseTX-Half]

Half-duplex communication method is set.

[AUTONEGOTIATION]

The communication method is set automatically.

5)Press as to select [STORE].

6)Press the <ENTER> button.

7)When the confirmation screen is displayed, press qw to select [OK], and press the <ENTER> button.

[DIGITAL LINK STATUS]

Display DIGITAL LINK connection environment.

1)Press as to select [DIGITAL LINK STATUS].

2)Press the <ENTER> button.

ff The [DIGITAL LINK STATUS] screen is displayed.

[LINK STATUS]

Either [NO LINK], [DIGITAL LINK], or [ETHERNET] is displayed.

[HDCP STATUS]

Either [NO SIGNAL], [OFF], or [ON] is displayed.

 

[SIGNAL QUALITY] is a numerical value of the amount of error, and the display color changes to

 

green, yellow, or red depending on that value.

 

Check the signal quality level while receiving a signal from the twisted-pair-cable transmitter.

 

ff MAX/MIN: Maximum/minimum value of the amount of error.

[SIGNAL QUALITY]

ff Green (-12 dB or lower) → Normal signal quality level.

 

ff Yellow (-11 to -8 dB) → Warning level where there is the possibility of noise introduced on the

 

screen.

 

ff Red (-7 dB or higher) → Abnormal level where synchronization may be interrupted or a signal may

 

not be received.

[NETWORK SETUP]

Perform the initial setting of the network before using the network function.

1)Press as to select [NETWORK SETUP].

2)Press the <ENTER> button.

ff The [NETWORK SETUP] screen is displayed.

3)Press as to select an item, and change the settings according to the operation instructions of the menu.

[PROJECTOR NAME]

Change the setting when using a DHCP server.

[DHCP]

Set to [ON] when obtaining an IP address automatically using a DHCP server. Set to [OFF] when not

using a DHCP server.

 

[IP ADDRESS]

Enter the IP address when not using a DHCP server.

[SUBNET MASK]

Enter the subnet mask when not using a DHCP server.

[DEFAULT GATEWAY]

Enter the default gateway address when not using a DHCP server.

[STORE]

Save the current network settings.

110 - ENGLISH