Chapter 4 Settings — [PICTURE] menu

3)Press qw to switch the item.

ff The items will switch each time you press the button.

[OFF]

No correction.

[ON]

Automatically corrects the aperture.

[DAYLIGHT VIEW]

You can correct the image to the optimal vividness even if it is projected under a bright light.

1)Press as to select [DAYLIGHT VIEW].

2)Press qw or the <ENTER> button.

ff The [DAYLIGHT VIEW] individual adjustment screen is displayed.

3)Press qw to switch the item.

ff The items will switch each time you press the button.

[AUTO]

The brightness of the room is detected by the luminance sensor, and the vividness of the image is

automatically corrected.

 

[OFF]

No correction.

[1]Corrects the image to weaken vividness.

[2]Corrects the image to medium vividness.

[3]Corrects the image to high vividness.

Note

ff When [PROJECTION METHOD] (x page 88) is set to [REAR/FLOOR] or [REAR/CEILING], [AUTO] cannot be selected. ff When objects, etc. are placed on the top of the projector, the [AUTO] mode may not function properly.

[SYSTEM SELECTOR]

The projector will automatically detect the input signal, but you can set the system method manually when an unstable signal is input. Set the system method matching the input signal.

1)Press as to select [SYSTEM SELECTOR].

2)Press the <ENTER> button.

3)Press as to select a system format.

ff Available system formats vary depending on the input signal.

Terminal

 

System format

<VIDEO IN> terminal,

Select [AUTO], [NTSC], [NTSC4.43], [PAL], [PAL‑M], [PAL‑N], [SECAM], or [PAL60].

Set it to [AUTO] normally. (Setting [AUTO] will automatically select [NTSC], [NTSC4.43], [PAL],

<VIDEO/G/Y>/<B/PB/C>

[PAL‑M], [PAL‑N], [SECAM], or [PAL60].)

terminals

Switch the setting to the signal method for the TV used.

 

<RGB 1 IN> terminal, <RGB 2

480i, 576i, or 576p signal

Select [RGB] or [YCBCR].

VGA60 or 480p signal

Select from [VGA60], [480p YCBCR], or [480p RGB].

IN> terminal

Other movie-based signals

Select [RGB] or [YPBPR].

 

 

480i, 576i, 480p, or 576p

Select [RGB] or [YCBCR].

<DVI-D IN> terminal

signal

 

 

Other movie-based signals

Select [RGB] or [YPBPR].

<HDMI IN> terminal, <DIGITAL

480i, 576i, 480p, or 576p

Select [AUTO], [RGB], or [YCBCR].

LINK/LAN> terminal,

signal

 

<DisplayPort IN> terminal

Other movie-based signals

Select [AUTO], [RGB], or [YPBPR].

4)Press the <ENTER> button.

Note

ff Refer to “List of compatible signals” (x page 148) for the types of video signals that can be used with the projector. ff This may not function properly for some connected external devices.

68 - ENGLISH