Chapter 4 Settings — [PROJECTOR SETUP] menu

Setting [NO SIGNAL SHUT-OFF]

A function that automatically switches the power of the projector to standby if there is no input signal for a certain period of time. The time before switching to standby can be set.

1)Press as to select [ECO MANAGEMENT].

2)Press the <ENTER> button.

ff The [ECO MANAGEMENT] screen is displayed.

3)Press as to select [NO SIGNAL SHUT-OFF].

4)Press qw to switch the item.

ff The items will switch each time you press the button.

[DISABLE]

Disables the No signal shut-off function.

[10MIN.] - [90MIN.]

Allows you to set in ten minutes intervals.

Setting [STANDBY MODE]

Set the power consumption during the standby.

1)Press as to select [ECO MANAGEMENT].

2)Press the <ENTER> button.

ff The [ECO MANAGEMENT] screen is displayed.

3)Press as to select [STANDBY MODE].

4)Press qw to switch the item.

ff The items will switch each time you press the button.

[ECO]

Use this setting to reduce power consumption during standby.

[NORMAL]

Use this setting to use the network function during standby.

Note

ff When [ECO] is set, the network function and some RS‑232C commands become inoperable during standby. When [NORMAL] is set, the network function becomes operable during standby.

ff When set to [ECO], it may take approx. 10 seconds longer before the projector starts projecting after the power is turned on, compared with when [NORMAL] is set.

ff The [STANDBY MODE] settings are not reset to their factory defaults when [ALL USER DATA] in [PROJECTOR SETUP] menu → [INITIALIZE] (x page 98) is executed.

[SCHEDULE]

Set the command execution schedule for each day of the week.

Enabling/disabling the schedule function

1)Press as to select [SCHEDULE].

2)Press qw to switch the item.

ff The items will switch each time you press the button.

[OFF]

Disables the schedule function.

[ON]

Enables the schedule function. Refer to “How to assign a program” (x page 90) or “How to set a

program” (x page 91) for how to set the schedule.

 

Note

ff When [SCHEDULE] is set to [ON], the [STANDBY MODE] setting is forcibly switched to [NORMAL], and the setting cannot be changed. Even if [SCHEDULE] is then set to [OFF] when in this state, the setting of [STANDBY MODE] remains at [NORMAL].

How to assign a program

1)Press as to select [SCHEDULE].

90 - ENGLISH